Introduction CreativeGates is a Fingerz only feature that allows you to create teleportation gates without running a single command. The plugin does not impose design restrictions. Design the gate frame any way you like. Gate networks Gates are connected to the other gates in the same network. The network name is chosen when creating the gate. The size, design or what materials you have in the frame does not matter. If you have 5 gates in the network “derpingschtein” those gates will link to each other like a snake biting it’s tail. Creating the gate A clock is used for the initial creation of the gate. Name the clock with an anvil and click the inside of the gate frame with the clock. A gate will be created using the clock name as the network name. Mind where you stand when you create the gate. That location will be used as the exit location for this gate. Inspecting the gate Blaze powder can be used on the gate to inspect it. When doing so you will see the network name and the amount of gates in the network. Usage of this tool can be restricted to the gate creator by using magma cream as explained below. Enabling and disabling enter and exit A blaze rod can be used on the gate to toggle whether enter and exit is enabled or disabled. If enter is disabled nothing will happen when you walk into it. If exit is disabled the gate won’t be used as an exit by other gates. Usage of this tool can be restricted to the gate creator by using magma cream as explained below. Restricting the gate Magma cream can be used on the gate to toggle whether the gate is restricted. Only the creator of the gate can do this. If the gate is restricted only the creator can use tools on the gate. This will for example make the network name secret.